Allied Telesyn International Corp TurboStack AT-S6 User's Guide download pdf (Page 63)

Chapter 5

Software Upgrades

This chapter describes the procedures to upgrade hub software.

The Omega ﬁrmware, AT-S10, is pre-loaded in manageable TurboStack

modules at the factory and is ready to use. There are various ways to

install or upgrade your ﬁrmware:

❑ Install the AT-S10 firmware cassette in the firmware port.

❑ Use TFTP.

❑ Upgrade the software in one TurboStack hub using the firmware

cassette, and then download to other TurboStack hubs on the

network.

❑ Connect a newly-bought TurboStack hub that has the latest

firmware version to the network and then download to other hubs

on the network.

NOTE

All TurboStack hubs on your network should be running the same version

of software. If you are installing a new standalone hub into a network that

has older TurboStack modules with old software, update the other hubs to

the latest version. When mixing TurboStack and AT-3600 hubs in a

chassis, all modules must be running AT-S4 firmware, version 3.0 or

greater.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 77 78

No comments

Allied Telesyn International Corp TurboStack AT-S6 User's Guide Page 63