Allied Telesyn International Corp TurboStack AT-S6 User's Guide download pdf (Page 66)

Software Upgrades

NOTE

You may leave the cassette installed. If you do, however, the module cannot

receive downloads over the network. This is because the software network

download does not overwrite a cassette. Password protection is also

disabled when the cassette is installed.

8. Plug the power cord back into the hub.

For a standalone hub, the software installation is complete.

9. Return the hub into the master uppermost slot in the chassis, if you

have a department concentrator configuration.

The other modules in the chassis are then automatically upgraded

from the master with no impact to the users on those modules.

Using the Download Menus

The Omega software site license permits you to update other TurboStack

hubs through the network. You don’t need to insert an AT-S10 ﬁrmwrae

cassette in each hub in the network or rack.

The download menus are for sending updated software from one

TurboStack hub to other TurboStack hubs in the network.

Omega uses the trivial ﬁle transfer protocol (TFTP) of the TCP/IP protocol

suite to download software to other switches whether or not your network

uses TCP/IP. TFTP is transparent to other devices on the network. Make

sure there is no ﬁrmware cassette installed in the hubs’ ﬁrmware port,

and they all have the same download password.

After updating the software in one hub, you can use the Omega menu on

that hub to send updated software to speciﬁc TurboStack hubs, or to all.

NOTE

You do not need to issue download commands if you are upgrading modules

via the master module. Once you insert a master module with the latest

software into the uppermost slot of the chassis, it automatically downloads

the software to other management hubs in the slots below.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 77 78

No comments

Allied Telesyn International Corp TurboStack AT-S6 User's Guide Page 66