Allied Telesyn International Corp AT-9448Ts/XP Installation Guide download pdf (Page 67)

AT-9400 Stack Installation Guide

Verifying the Installation

The section contains procedures for verifying the installation of the stack

from a local management session on the master switch. There are two

procedures. Perform “Verifying a Stack with Static ID Numbers,” next if the

switches have static module ID numbers. Otherwise, perform “Verifying a

Stack with Dynamic Module ID Numbers” on page 69.

Verifying a Stack

with Static ID

Numbers

To verify the installation of a stack where the switches have static module

ID numbers, perform the following procedure:

1. After powering on the stack, wait a least two minutes. This is to give

the switches sufficient time to initialize their management software and

complete the discovery process.

2. Examine the Stack MSTR LED on the front panel of the switch labelled

1 in “Labelling the Switches” on page 56. As the master switch of the

stack, its Stack MSTR LED should be green. (Do not confuse the

Stack MSTR LED with the Status MASTER LED. The latter is used

with enhanced stacking, a feature not supported on a stack.)

Note

If the Stack MSTR LED on the switch labelled 1 is off, examine the

same LED on the other switches of the stack. If all the Stack MSTR

LEDs are off, the discovery process may have encountered a

problem. For suggestions on resolving it, refer to “Troubleshooting

the Discovery Process” on page 71.

3. Establish a local management session on the master switch. For

instructions, refer to “Starting a Local Management Session” on

page 53.

4. At the command line prompt, enter this command:

show stack

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 99 100

No comments

Allied Telesyn International Corp AT-9448Ts/XP Installation Guide Page 67