Allied Telesyn International Corp AT-9448Ts/XP Installation Guide download pdf (Page 48)

Chapter 2: Installing the Hardware

Installing the Power Cord Retaining Clip (AC Switches Only)

Perform the following procedure to install the power cord retaining clip on

the switches:

1. Locate the power cord retaining clip, shown in Figure 12.

Figure 12. Power Cord Retaining Clip

2. Install the clip on the AC power connector on the back panel of the

switch. With the “u” of the clip facing down, press the sides of the clip

toward the center and insert the short ends into the holes in the

retaining bracket, as shown in Figure 13.

Figure 13. Inserting the Retaining Clip into the Retaining Bracket

You are now ready to install the switches in the equipment rack, as

explained in the next procedure.

100-240VAC

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 99 100

No comments

Allied Telesyn International Corp AT-9448Ts/XP Installation Guide Page 48