Allied Telesyn International Corp AT-9448Ts/XP Installation Guide download pdf (Page 61)

AT-9400 Stack Installation Guide

Assigning a Static Module ID Number to the Member Switches

This procedure assigns a static ID number to the member switches of the

stack. This procedure must be performed on each switch before the cables

are connected to the AT-StackXG Stacking Modules.

To assign the static module ID number 2 to the switch labelled 2, perform

the following procedure:

1. Power on and initiate a local management session on the switch

labelled 2 in the stack. For instructions, refer to “Powering on a Switch”

on page 52 and “Starting a Local Management Session” on page 53.

2. Issue the SHOW STACK command to display the switch’s current

module ID value.

3. Enter one of the following commands.

If Stack Mode is Auto, change the dynamic Stack ID value of 1 to the

static value of 2 with this command:

set stack moduleid=1 newmoduleid=2

If Stack Mode is Static and Stack ID is a value other than 2, enter the

following command, where n is the current value of Stack ID:

set stack moduleid=

newmoduleid=2

For example, if the current value of My ModuleID is 4, the command

would be:

set stack moduleid=4 newmoduleid=2

If Stack Mode is Static and Stack ID is 2, no command is necessary.

4. Reset the switch with the RESTART REBOOT command.

5. Reestablish your management session and issue the SHOW STACK

command to verify that Stack Mode is Static and Stack ID is 2.

6. Power off the unit.

7. Repeat this procedure on the next switch, incrementing the value for

the Newmodule parameter in the command in step 3, as necessary.

After assigning and verifying the stack ID numbers on all the switches, go

to the next procedure to cable the stacking modules.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 99 100

No comments

Allied Telesyn International Corp AT-9448Ts/XP Installation Guide Page 61