Allied Telesyn International Corp AT-9448Ts/XP Installation Guide download pdf (Page 58)

Chapter 3: Preparing the Switches of the Stack

Assigning the Static Module ID Number 1 to the Master Switch

This procedure assigns the static module ID number 1 to the master

switch of the stack.

1. Establish a local management session on the device labelled “1” in

“Labelling the Switches” on page 56. For instructions, refer to “Starting

a Local Management Session” on page 53.

2. Enter the following command to view the switch’s current module ID

assignment:

show stack

Note

If the switch displays the message “CLI Command Not Found or

Ambiguous,” update the AT-S63 Management Software on the unit.

Figure 22 is an example of the display.

Figure 22. SHOW STACK Command

This command displays the following information:

 Local MAC Addr: The MAC address of the switch.

 Standalone Mode ID: The module ID number of the switch when

the device is not a part of a stack. This parameter can be ignored.

 Stack Mode: The method by which the module ID number was

assigned. Auto means the number was assigned dynamically by

the management software when the switch was powered on. Static

means the number was assigned with the SET STACK command.

 Stack ID: The switch’s current module ID number.

 Stack Priority: The switch’s current stack priority value, used to

control dynamic module ID numbers. For an explanation of stack

priority values, refer to the AT-S63 Stack Command Line Interface

User’s Guide.

When the switch is part of a stack, the units in the stack are listed in a

table. Since the unit is not yet part of a stack, the table is omitted.

Local MAC Addr :00:30:84:00:00:03

Standalone Mode ID :1

Stack Mode :AUTO

Stack ID :1

Stack Priority :16

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 99 100

No comments

Allied Telesyn International Corp AT-9448Ts/XP Installation Guide Page 58