Allied Telesyn International Corp AT-WA7500 Installation Guide download pdf (Page 30)

Do not use a cross-over cable to connect

another AT-FS705LE switch to the Uplink

port.

Note

You can use either port 5 or the Uplink

port, but you cannot use both

simultaneously.

8. Go to the procedure “Verifying and

Troubleshooting the Installation” on page 16.

Verifying and Troubleshooting the

Installation

The following procedure should be perform

after you have initially installed the unit to

check to be sure that the switch is operating

properly. You can also perform this procedure

to troubleshoot the unit in the event you

experience any problems with the device.

1. Check the Power LED. The LED should be

ON. If the Power LED is OFF, check the

following:

❑ Check to be sure that the power adapter is

securely connected to the power source

and to the DC connector on the front of the

AT-FS705LE switch.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 50 51

No comments

Allied Telesyn International Corp AT-WA7500 Installation Guide Page 30