AT-FS705LE Installation Guide
13
Installing the Unit on a Desktop
To install the switch on the desktop, perform
the following procedure. To mount the unit on a
wall, perform the steps “Installing the Unit on a
Wall” on page 14.
1. Attach the four self-adhesive rubber feet to
the bottom of the switch, positioning them in
the indentations.
2. Place the switch on a flat, level surface.
3. Plug the power adapter into the power
receptacle, then plug the DC power cord into
the DC connector on the front panel of the
switch.
Warning
The power cord is used as a
disconnection device. To de-energize
equipment, disconnect the power cord.
5
4. Make sure the Power LED on the front panel
lights green.
Comments to this Manuals