Allied Telesyn International Corp AT-WA7500 Installation Guide download pdf (Page 22)

Installation

Hub to MAU Wiring. The most typical UTP cable for the AT-MR415T/

AT-MR815T Micro Repeater will be UTP Hub-to-UTP transceiver Data

Terminal Equipment (DTE).

To conﬁgure your own cables, see Appendix A, “Technical Speciﬁcations” on

page 23.

Quick Installation

If you are experienced with electronic networks in general and repeaters in

particular, use the following procedure. If you are not certain, or would like to

review the installation process, read this list and go on to the next section.

1. Carefully unpack your AT-MR415T/AT-MR815T Micro Repeater. Keep the

packing materials until you have successfully installed the product.

2. Place the AT-MR415T/AT-MR815T Micro Repeater in a location with

adequate ventilation and power receptacles.

3. Attach the power cable from your AC adapter into the DC-IN port which is

located on the back panel.

Note

Power to the hub must be sourced only from the direct plug in type

approved adapter rated 7.5Vdc, 500mA.

4. Apply power to the AC adapter by plugging it into an appropriate AC

source.

5. Attach your 10Base-T UTP cables, with RJ-45 connectors attached, to the

10Base-T ports. If the UPLINK port is not used for cascading, you may

connect a standard 10Base-T cable to port 4/8.

Note

Do not connect standard telephone line into the signal connector.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

No comments

Allied Telesyn International Corp AT-WA7500 Installation Guide Page 22